a.
b.
c.
d.
e.
f.
g.
h.
Male connector
Female connector
Installation steps
1.
Before installation, make sure the power supply
is switched off.
2.
Attach the spike to the light via the screw
provided.
3.
Adjust the orientation of the garden light to the
desired angle and tighten the screw.
4.
Spread the connection cable in your garden
placing the cable end with male connector near
the outdoor power point.
5.
Connect the garden lights to the cable via the
provided connections. Make sure you align the
notch in the connectors before connecting them.
Tighten the connector cap to seal the connection
and stake the light into the ground.
6.
Mount the LED driver on a surface such as wall
using the 4 screws (figure f.) provided, if required.
7.
Connect the LED driver to the connection cable
and screw the cap to seal the connection.
8.
If all garden lights are not used, seal the open
connectors using the connector plugs provided.
9.
Connect the 3-pin plug of the driver to the AC
mains socket and switch the power supply on.
Notes
1.
Make sure the LED driver and the garden light are
not sited such that they get flooded with water.
2.
Ensure all connections are tight and sealed by
tightening the connector cap.
3.
Do not leave any connector open.
Cleaning
Before cleaning, disconnect from mains supply and allow
the garden light to cool. Only use a damp, microfibre cloth
for cleaning. A diluted solution of a mild pH-neutral liquid
detergent can be used for resistant dirt. Do not use high
pressure cleaners.
g
a
c
e
