Hyundai H-1415, Instruction Manual, Page: 8 / 17

7
release it.
Press STOP/EJECT button when finished. Then stop CD playback by pressing the CD STOP/FOLDER button of the CD player.
Notes:
You may want to monitor during recording. You can adjust the sound with VOLUME control regulator. These adjustments do not affect the content of
recording.
This deck is not suitable for recording on CHROME (IEC II) or METAL (IEV IV) type cassettes. For recording use NORMAL type cassette (IEC I) on
which the tabs have not been broken.
At the very beginning and end of the tape, no recording will take place during the 7 seconds, when the leader tape passes the recorder heads.
When in process of recording or playback the end of the tape is reached, the tape stops automatically and the relevant button is released.
Dynamic bass boost system
For increased bass at all volume levels, press the DBBS button to boost the low frequency tone for an emphasized bass sound.
Maintenance and care
Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or
is being run exclusively on the alternative power, remove the batteries to avoid leakage and damage.
Electronic products of this kind should never be subjected to moisture or extreme temperatures.
If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from
the power supply).
The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to
clean these parts. Never touch the heads with anything metallic.
Erase protection
To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tape’s rear side.
When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.
If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs were removed, with a
piece of strong adhesive tape.
CD protection
When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would scratch the disc surface and
may occur sound distortion or raise reading problem.