Hyundai Coupe Tiburon 2007, Owner'S Manual

Page: 408 / 487

3
IN CASE OF EMERGENCY
10
HGK4014
D060H02A-EAT
7. Reinstall Wheel Nuts
To reinstall the wheel hold it on the
studs put the wheel nuts on the studs
and tighten them finger tight. The nuts
should be installed with their small
diameter ends directed inward. Jiggle
the tyre to be sure it is completely
seated, then tighten the nuts as much
as possible with your fingers again.
D060I01E-EAT
8. Lower Vehicle and Tighten
Nuts
Lower the car to the ground by inserting
the wheel nut wrench into the wrench
bar and turning the wheel nut wrench
counterclockwise.
Then position the wrench as shown in
the drawing and tighten the wheel nuts.
Be sure the socket is seated com-
pletely over the nut. Do not stand on the
wrench or use an extension pipe over
the wrench handle.
OGK036604 !
WARNING:
Wheels and wheel cover may have
sharp edges. Handle them carefully
to avoid possible severe injury.
Before putting the wheel into place,
be sure that there is nothing on the
hub or wheel (such as mud, tar,
gravel, etc.) that interferes with the
wheel from fitting solidly against
the hub. If there is, remove it. If
there is not good contact on the
mounting surface between the
wheel and hub, the wheel nuts could
come loose and cause the loss of a
wheel. Loss of a wheel may result in
loss of control of the vehicle. This
may cause serious injury or death.
OGK036603