4 189
Features of your vehicle
VOICE RECOGNITION
(if equipped model)
Using Voice Recognition
Starting Voice Recognition
Shortly press the
key on the steer-
ing wheel. Say a command.
If prompt feedback is in [ON], then the
system will say “Please say a command
after the beep (BEEP)”
• If prompt feedback is in [OFF] mode,
then the system will only say “(BEEP)”
• To change Prompt Feedback
[On]/[Off], go to
[System]
[Prompt Feedback]
✽
✽
NOTICE
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Contact List Best Practices
1)Do not store single-name entries (e.g.,
“Bob”, “Mom”, “Kim”, etc.).
Instead, always use full names (includ-
ing first and last names) for all contacts
(e.g., use “Jacob Stevenson” instead of
“Dad”).
2)Do not use abbreviations (i.e., use
“Lieutenant”
instead of “Lt.”
or
“Sergeant” instead of “Sgt.”).
3)Do not use acronyms (i.e., use “County
Finance Department”
instead of
“CFD”).
4)Do not use special characters (e.g.,
“@”, “hyphen -”, “asterisk *”, “amper-
sand &”).
5)If a name is not recognized from the
contact list, change it to a more
descriptive name (e.g., use “Grandpa
Joseph” instead of “Pa Joe”).
Skipping Prompt Messages
While prompt message is being stated
Shortly press the
key on the steer-
ing remote controller.
The prompt message is immediately
ended and the beep tone will sound.
After the “beep”, say the voice command.
Re-starting Voice Recognition
While system waits for a command
Shortly press the
key on the steer-
ing remote controller.
The command wait state is immediately
ended and the beep ton will sound. After
the “beep”, say the voice command.
SETUP
CLOCK