INSTRUCTION MANUAL FOR RF COMMUNICATION MICROWAVE MOTION SENSOR
MODEL NO.: HC028V/RF
Technical Specifications
This is a combination of motion sensor and RF radio wave wireless transmission. The motion detected by 1 sensor (the
master unit) can pass onto other pre-defined individuals (the slave units) through RF transmission. Thanks to fixed address
code technology, it’s easy to set up point-to-point or point-to multipoint transmission.
Note: the RF signal would be affected by big metal plate, frames, thick obstacle or special frequent electromagnetic waves
radiation.
Section 1 Installation and Wiring
1.1 Ensure that the electricity supply is switched off before installing or servicing this product.
1.2 Wiring diagram
Product type:
Operation voltage:
Rated load:
HF detection range:
Time setting:
Stand-by period:
Stand-by dimming level:
Daylight threshold:
Installation height:
Working temperature:
HF system:
Coding system:
RF frequency:
RF transmission distance:
RF microwave motion sensor
220-240VAC 50/60Hz
400W (capacitive load)
Max. 12m in diameter, adjustable
5s ~ 30min.
0s, 10s ~ 1h, +∞
10% ~ 50%
2 ~ 50Lux, disable
Max. 6m
-20
℃
~ +60
℃
5.8GHz CW radar
Fixed address coding with 16 channels
FSK 868MHz (315MHz / 433MHz / 915Mhz upon request)
30 meters indoor, 100 meters in open area
Antenna module
LED indication
Daylight sensor
RF antenna
Installation hole
1-10V
Push
Detection area
Hold-time
Rotary coding switch(TX)
Rotary coding switch(RX1)
Rotary coding switch(RX2)
Stand-by period
Stand-by dimming level
Brightness on RF signal
Daylight sensor
3rd Floor, block C, complex building, 155#, Bai'gang road south,
Bai'gang village, Xiao Jin Kou town, Huicheng district, Huizhou 516023
Tel:86-752-2772020 F:86-752-2777877
E: [email protected] W:www.hytronik.com
CHINA FACTORY
Room D, 10/f, Tower A, Billion Center, 1 wang Kwong Road,
Kowloon Bay, Kowloon, Hongkong
T: 00852-35197525 F: 00852-30116936
E: [email protected]
HYTRONIK INDUSTRIAL LIMITED
