Hyster H40-60XT, Operating Manual

Page: 80 / 180

11. Press ◄ until LoOO kG - SET nnn displays.
12. Raise forks 30 to 40 mm (12 to 16 in.).
13. Press and hold ◄ for two seconds.
14. Press ► until yES displays.
15. Press M to save value.
It is important to make sure that load weight meter is read-
ing as close to actual weight of loads being lifted as possi-
ble. If weights differ, adjust controller code 512.
1. While viewing load meter on display, lift a load of a
known weight.
2. If load weight on display matches known weight, stop
here. If load weight on display does not match known
weight of the object, proceed to the next step.
3. Divide know weight by displayed weight to learn the per-
centage at which to set controller code 512.
For example, if the know load weight is 500 kg. but display
reads 530 kg., the percentage is 94.
4. Set controller code 512 to the percentage identified in
previous step. See Calibratons Procedures
8000SRM2003, Controller Setting for procedures.
Load Meter
Your lift truck may be equipped with an optional load meter.
The load meter calculates mast pressure and converts that
pressure into a load value (weight) that will be displayed by
pressing the mode change button (
M ) with lift truck stop-
ped.
If the carriage and/or forks are replaced the load meter
needs to be reset. To set the load meter function use the
following procedure. Refer to
Figure 8 during load meter
set procedure.
1. After turn key switch to ON position, press mode change
button ( M ) for eight or more seconds until oPE SET screen
appears.
2. Press display change button (<) one time to select 0 kg
set menu until Lo00 AUT SET screen appears.
3. With NO load on the forks, place mast assembly in verti-
cal position. It is recommended that mast and forks are in a
90° (±1°) angle for set procedure.
4. Press display change button (>) to begin 0kg set mode.
With a second push of the display change button (>) the
pressure reading date will begin.
Operating Procedures
78