Hyster H40-60XT, Operating Manual

Page: 79 / 180

run off the edge of the travel surface onto soft ground, the
lift truck can tip over.
12. Under all travel conditions, operate the lift truck at a
speed that will permit it to be brought to a stop in a safe
manner.
Set Up the Load Weight Sensor
Understanding the A/D (Analog to Digital) Value
The weight stored as 0 on the load meter accounts for the
weight of moving mast channels, carriage, and forks.
The A/D value displayed on load meter set screens indi-
cates in hexadicimal (HEX) format the weight currently
stored as a zero value of load weight sensor. Each HEX bit
is equivalent to about 7 kg (2.2 lb).
To calculate weight stored for zero value, convert A/D
value from HEX to decimal format, then multiply by 7. For
example, if A/D reading is 70 in HEX:
70 => 112 * 7 kg = 784 kg (1725 lb)
Store a Value for Zero on the Load Meter
1. Enter Service Mode.
2. Enter service password, if enabled.
3. Turn truck ON .
4. Set mast to vertical position perpendicular to floor.
5. Lift forks 30 to 40 cm (12 to 15 in.) from floor.
6. Lower mast to floor.
7. Press ►until SET1 - AdJUST displays.
8. Press ◄ until ConT - AdJU displays.
9. Press ► until LPFS - SET displays.
10. Press ◄ until LoOO kG - nnn displays.
The current A/D value is displayed below LoOO kG .
Operating Procedures
77