Hyster H40-60XT, Operating Manual

Page: 14 / 180

protect the operator against all possible injury in a tipover.
The hip restraint will help the operator resist side move-
ment. It is not a substitute for the seat belt. Always fasten
the seat belt.
This lift truck is equipped with one of the three seat belt
configurations.
• Seat belt with no operation interlock.
• Seat belt with operation interlock. Seat belt must be fas-
tened for lift truck to start or to travel.
Nameplate
WARNING
DO NOT add to or modify the lift truck. Any modifica-
tion that affects the safe operation of the truck cannot
be undertaken without the written authorization of Hys-
ter Company.
Any change to the lift truck, the tyres, or its equipment
can change the lifting capacity. The lift truck must be
rated as equipped and the Nameplate must show the
new capacity rating.
The capacity is specified in kilograms (kg) and pounds (lb).
The capacity is the maximum load that the lift truck can
handle for the load condition shown on the Nameplate.
The maximum capacity for the lift truck, at full load height,
must be shown on the Nameplate. Special capacities with
the load height reduced or with optional load centers, may
also be shown on the Nameplate.
The lift truck serial number code is on the Nameplate. The
serial number code is also stamped on the right-hand side
of the lift truck frame, under the floorplate.
When a lift truck is shipped incomplete from the factory, the
Nameplate is covered by an INCOMPLETE label as shown
in
Figure 2 . If the equipment on the truck is changed, the
Nameplate is covered by a NOTICE label as shown in Fig-
ure 2 . If your lift truck has either of these labels, do not
operate the lift truck. Contact your dealer for Hyster lift
trucks to obtain a complete correct Nameplate.
Model Description
12