© 2022 HyQuest Solutions
16
Configuration
3.4
Tare
Choose, if tare or tapping should be indicated
§
Measure (Actual)
: If a current measured value is available, it will be shown here. If not, it will display “No value”. In
that case, the current value can be measured and displayed by clicking the button “Measure...”.
§
Set Point (Nominal)
: Enter the required current value. This can be a currently measured tapping or the water level
taking the main sea level into account.
§
Calculate and OK
: If all settings are completed, click “Calculate and OK”. The software now calculates the values for the
data fields “Offset” and “Multi”.
§
Reset calibration
: Set the values for Multi and Offset to the default settings (Offset = 0.00, Multi = 1.00)
§
Cancel
: Close the windows without changing any settings.
