Hypertherm XPR300, Instruction Manual, Page: 166 / 402

Connect for Communication
4
166 809480 Instruction Manual XPR300
Web interface screen information
If you replace the control PCB, the information stored on the PCB changes. This includes the MAC
address, System ID, passwords, and network information.

System ID – This is the identifier for the plasma power supply. It is the last 4 digits of the
MAC address. The MAC address is printed on the wireless module on the control PCB.

Operator ID – This is the identifier for the device or
client that has control of the plasma power supply. The
first part of the Operator ID shows the type of
connection that sent a process,
WiFi for wireless, Uart
422 for serial RS-422, or EtherCAT for EtherCAT.

To change which device has control of the plasma power supply, see How
to change the device that has control on page 180.

Client ID – This is the identifier for a device that communicates with the plasma power
supply. This ID uses the UTC time stamp and is saved in a browser cookie.

If the Client ID and the Operator ID are the same on your device, you are
in control of the plasma power supply.

Connection – This is the status of the communication between the device and the plasma
power supply. (Good or Error.)