Troubleshoot Common Problems
6
124
810470
Operator Manual
Powermax65/85/105 SYNC
Cold restarts and quick restarts
To restart the plasma power supply, set the power switch
on the plasma power supply to OFF (
O
) and then set the
power switch to ON (
I
).
In some conditions, it is possible that you will be asked
specifically to do a “cold restart” or a “quick restart.”
Do a cold restart
1.
Set the power switch on the plasma power supply to OFF (
O
).
2.
Wait until all the amperage LEDs on the SmartSYNC hand torch go off. If you are using a
machine torch, wait approximately 1 minute.
3.
Set the power switch on the plasma power supply to ON (
I
).
Do a quick restart
1.
Set the power switch on the plasma power supply to OFF (
O
).
2.
Immediately set the power switch on the plasma power supply to ON (
I
).
If a fault occurs while you are using a generator, a quick restart does not
always remove the fault. Do a cold restart instead.
The system changes the
output current (A) or the
operating mode after I set
them.
• Set the torch-lock switch to the “ready to fire” (
) position
before
you
adjust the amperage or operating mode. The system does not keep those
settings while the torch-lock switch is in the yellow lock (
X
) position. When
you set the torch-lock switch to the “ready to fire” (
) position, the system
automatically sets the amperage and operating mode to match the type of
cartridge installed on the torch. Refer to
.
The LCD screen shows a
FACTORY RESET?
message when I try to go
to the service screens.
• The
FACTORY RESET?
message shows when you push and hold
and
for approximately 2 seconds. The
Cancel
button is
selected by default. Push
to cancel the reset and go back to the
screen you were on without making changes. Refer to
for more
information.
• To go to the service screens, push and hold
for 2 seconds. Refer to
Problem
Solution
Summary of Contents for SYNC Powermax 105
