Hypertherm HyPrecision 15, Operator'S Manual

Page: 13 / 194

Product stew
a
rd
s
hip
Safety and compliance SC-13
Product stewardship
Hypertherm maintains a global Regulatory Management System to ensure that products comply with regulatory and
environmental requirements.
National and local safety regulations
National and local safety regulations shall take precedence over instructions supplied with the product. The product shall
be imported, installed, operated and disposed of in accordance with national and local regulations applicable to the
installed site.
Certification test marks
Certified products are identified by one or more certification test marks from accredited testing laboratories. The
certification test marks are found on or near the data plate.
Each certification test mark means that the product and its safety-critical parts conform to the relevant national safety
standards as reviewed and determined by that testing laboratory. Hypertherm puts a certification test mark on its
products only after that product is manufactured with safety-critical parts that have been authorized by the accredited
testing laboratory.
Once the product has left the Hypertherm factory, the certification test marks are invalidated if any of these events occur:
 The product is modified in a manner that creates a hazard or nonconformance with the applicable standards.
 Safety-critical parts are replaced with unauthorized spare parts.
 Assembly is unauthorized.
 An accessory that uses or generates a hazardous voltage is added.
 There is tampering with a safety circuit or other feature that is designed into the product as part of the certification,

or otherwise.
A Conformité Européene (CE) mark constitutes a manufacturer’s declaration of conformity to applicable European
directives and standards. Only those versions of Hypertherm products with a CE mark found on or near the data plate
have been tested for compliance with the European Low Voltage Directive and the European Electromagnetic
Compatibility Directive.
Declaration of conformity
This Declaration of Conformity applies to these HyPrecision Waterjet Pump models based on testing of the
HyPrecision™ 50S model:
Date of first fixing of Conformité Européene (CE) mark (Declaration of Conformity issued): 15 June 2010
HyPrecision 15 HyPrecision 50S HyPrecision 100D
HyPrecision 30 HyPrecision 60S HyPrecision 150D
HyPrecision 50 HyPrecision 75S