Hypertherm HyPerformance Plasma HPR400, Instruction Manual

Page: 41 / 355

InstallatIon
HPR400XD Auto Gas – 806160 3-3
Upon receipt
• Verify that all system components on your order have been received. Contact your supplier if any items
are missing.
• Inspect the system components for any physical damage that may have occurred during shipping. If there is
evidence of damage, refer to Claims. All communications regarding claims must include the model number and
serial number located on the rear of the power supply.
claims
claims for damage during shipment – If your unit was damaged during shipment, you must file a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance, call
Customer Service listed in the front of this manual, or your authorized Hypertherm distributor.
claims for defective or missing merchandise – If any of the merchandise is defective or missing, contact your
supplier. If you need additional assistance, call Customer Service listed in the front of this manual, or your authorized
Hypertherm distributor.
Installation requirements
All installation and service of the electrical and plumbing systems must conform to national and local
electrical and plumbing codes. this work should be performed only by qualified, licensed personnel.
Direct any technical questions to the nearest Hypertherm Technical Service Department listed in the front of this manual,
or your authorized Hypertherm distributor.
Noise levels
Acceptable noise levels as defined by national and local codes may be exceeded by this plasma system. Always
wear proper ear protection when cutting or gouging. Any noise measurements taken are dependant on the specific
environment in which the system is used. See also Noise can damage hearing in the Safety section of this manual.
Specific information by product can be found in the Hypertherm downloads library at:
https://www.hypertherm.com/Xnet/library/DocumentLibrary.jsp
Select the product you are looking for from the Product Type drop down menu, choose “Regulatory” from the Category
drop down menu, and choose “Acoustical Noise Data Sheets” from the Sub Category drop down menu. Hit Submit.
Placement of system components
• Place all system components in position prior to making electrical, gas, and interface connections. Use the
diagram in this section for component-placement guidelines.
• Ground all system components to earth. See Recommended grounding and shielding practices in this section
for details.
• To prevent leaks in the system, tighten all gas and water connections as shown below:
torque specifications
gas or water hose
size kgf-cm lbf-in lbf-ft
Up to 10 mm (3/8 in) 8.6-9.8 75-85 6.25-7
12 mm (1/2 in) 41.5-55 360-480 30-40