Hypersen Technologies Co., Ltd.
HPS-FT-USER V1.8
32
/
38
4. After modifying the baud rate, click OK to make it take effect immediately.
5.Click the
Save user setting
button on the
Advanced setting
menu, and then the relevant
parameters will remain valid after shutdown.
6. Turn off the sensor and then restart it. Connect it to the host again with the updated baud rate.
6 Host monitoring software
The sensor has a reserved monitoring port in addition to the main communication port. You can monitor and
acquire data in real time through the host monitoring software without affecting the communication between
the main port of the sensor and the equipment. This is convenient for debugging and data analysis.
6.1. Host demonstration software connection steps
Steps: 1. Provide a PC with Windows system.
2. Set the network port of the PC. Make sure that the PC and the sensor are in the same network
segment 192.168.1.X and do not conflict with each other.
3. Copy and decompress the host monitoring software. Find the file “Monitoring.exe” in the Release
folder and double-click it to open it.
4. Enter the PC port IP and the sensor IP. Click
OK
, as shown in the figure.