Hyper Extension HOME GYM 50036, Owner'S Manual, Page: 16 / 27

- 16 -
A.) Attach the 3980 Upper Cable (#31) to the opening on the front Upper Frame (#4). Make
sure the ball stopper is underneath the Frame. Attach a Pulley (#43) to the Cable.
Secure the Pulley with one M10 x 65mm Allen Bolt (#80), two Pulley Bushings (#56),
and one M10 Nylon Nut (#88).
B.) Draw the Cable over the Pulley along the Upper Frame towards the back of the
machine to the opening in the middle of Upper Frame. Repeat Procedure B above to
install a Pulley.
C.) Draw the Cable around the Pulley then back to the upper open bracket on the back of
Front Press Base (#10). Attach a Pulley to the bracket. Secure it with one M10 x 45mm
Allen Bolt (#81), two
∅
10mm Washers (#87), and one M10 Nylon Nut (#88).
D.) Draw the Cable around the Pulley then towards the upper opening on the Vertical
Frame (#5). Repeat Procedure B above to install a Pulley.
E.) Draw the Cable around the Pulley and back to the lower open bracket on the back of
Front Press Base (#10). Repeat Procedure C above to install a Pulley.
F.) Draw the Cable around the Pulley then to the lower opening on the Upper Frame.
Repeat Procedure B above to install a Pulley.
G.) Draw the Cable underneath the Pulley then pull upward to the open bracket underneath
the Upper Frame. Repeat Procedure C above to install a Pulley.
H.) Draw the Cable around the Pulley then downward. Attach a Pulley to the two Double
Floating Pulley Brackets (#24). Repeat Procedure C above to install a Pulley. Let the
Bracket hanging for now.
I.) Draw the Cable around the Pulley then upward to the opening on the back of Upper
Frame. Repeat the Procedure C above to install a Pulley.
J.) Draw the Cable around the Pulley then downward to the Selector Rod (#41). Thread the
Head Bolt at end of the Cable into the Selector Rod.
DIAGRAM 8