Installation Manual Chapter4.System Installation
©
Hyosung TNS, Inc.
All Rights Reserved. 4-1
Chapter4. System Installation
Unpacking the ATM
► Unpack the machine on top of the palette.
1. Cut the straps that are fastened around the box with a knife.
(Be careful when cutting the straps. Refer to figure below.)
2. Use an appropriate tool to remove the nails from the palette. (Refer to figure below)
3. Remove the lid, then box from the top. Do not discard the packaging materials until you
have verified any shipping damage claim. Contact your distributor immediately if you see any
shipping damage. Store the box in a safe place to re-use or discard of appropriately.
4. Verify the contents carefully with the packing list to be sure all items listed are included.
Notify your distributor of any shortages.
5.
If only the palette needs to be removed, lift the whole machine from the bottom and set it
aside.
PRECAUTION:
MX8300D / 8300T ATM machine is very heavy equipment and can cause injuries if not handled
with caution. Read the following carefully.
▪ Firmly close the vault door and lock the door by turning the knob completely.
▪ Only experienced staff members should move the heavy machine.
▪ Do not tilt the ATM when moving.
