Hydrotechnik MultiSystem 4070, Operating Instructions Manual, Page: 74 / 153

Firmware Version 2.0 MultiSystem 4070
74
Operating software
ENG
 Configure special channels (Ch8 ... Ch17)
The special channels are used to mathematically combine the measured va-
lues of several sensors and do calculations with it, or to be configured as input
channels for the CAN bus.
Calculation Choose between the different occupations of the channel (see further below)
 See Possible assignments of the special channels on page 75.
Measurand Is entered automatically when using pre-programmed formulas and cannot be
edited;
For individual formulas and assignment with CAN you may define the measu-
rand that is provided on this channel here.
Index Measurand If Channel numeration is set to MANUAL in the General settings menu (see
General Settings on page 96), you may enter the index number of the chan-
nel here.
Unit Is entered automatically when using pre-programmed formulas and cannot be
edited;
Define the unit for channels with individual formulas and assignment with
CAN.
LOAD Loads sensor parameters from the database.
SAVE Stores the current sensor parameters in the database.
OK Confirms input/saves changes.