Firmware Version 2.0
MultiSystem 4070
120
Instrument functions
ENG
Define CAN channel
After you have set a calculation channel to
CAN
, you can select measurand
and unit from a list or enter them freely. Then you have to define the CAN pa-
rameters. Please have the documentation of the CAN sensor available; all
required information is included there.
1
Select the
Specification
:
.
2
Enter the
Timeout
:
.
3
Enter the
Identifier
as a decimal number or hexadecimal value.
Change the input format (decimal/hexadecimal):
The corresponding value is displayed in decimal numbers and the corre-
sponding hexadecimal value is in brackets –
.
4
Select the
Format
:
.
Depending on the selected format, further input options are displayed.
5
Select the
Channel name
.
Note
The CAN bus must be activated in the Device menu to enable the use of a CAN
channel. See chapter CAN configuration on page 90
LOAD
Loads sensor parameters from the database.
SAVE
Stores the current sensor parameters in the database.
OK
Confirms input/saves changes.