With the
MultiSystem 5060
Plus,
you can program the electronically controlled load valve
HySense QL 326
and
operate it in various operating modes.
Activating the CAN-BUS
Start the
MultiSystem 5060
Plus
and activate the CAN bus in the "DEVICE" menu. Set the baud rate to
125kBit/s. With F5 (OK) you leave the menu.
1
Press
to open the menu.
2
Use
to highlight
Device
and press
.
3
Use
to highlight
Can
and press
.
4
Use
to highlight the
Baud rate
and press
.
5
Use
to select select
125kBit/s
and press
.
6
Exit the settings with F5
(OK).
Starting the application Load valve
Select the "Special Applications" menu and open the menu with
. Select the "Load valve" menu.
1
Press to
open the menu.
2
Use
to highlight
Special Applications
and press
.
3
Use
to highlight
Load valve
and
press .
4
Via F3 (CONFIG) the connected sensors are recognized. Select "YES",
to add the sensors to the display.
5
Confirm with the
menu "Load valve" - CAN-BUS is scanned again
and you reach the programming level.
6
Use
to highlight
Parameter
and press
.
You are now at the programming level of the load valve.
In the "Parameter" menu you can set the operating mode "MANUAL", "RAMP", "SINUS" or "INACTIVE".
4
OPERATION WITH MS5060 PLUS
