HydroLogic Hydroid, User Manual, Page: 15 / 38

Hydroid
– Series User Manual
15 04/19
SYSTEM PURGING / INITIAL START
–UP
LEAVE THE SYSTEM UNPLUGGED FROM POWER UNTIL STEP 5
1. Remove dust caps and short tubes from all ports: PRODUCT (purified water - blue tubing),
CONCENTRATE (drain - black tubing), and FEED (inlet - white tubing). Install the provided
white tubing to FEED port for inlet water. Install a red clip (included in system parts bag) on
FEED port to lock tubing in place. Install other end of white FEED line to tap/source water,
or use included garden hose connector (included in system parts bag).
Refer to page 19, step 3 for quick-release port instructions.
2. The open end of the pre-installed
½” black tubing labeled “Flush” (B) goes to a drain.
Now you can begin to slowly turn on the water supply and flush the dust from the carbon
pre-filter, until water stream is clear (approx. 5 min).
3. Re-install System Tubing for Normal Operation : Remove red clip (A
), disconnect ½”
black Flush tubing (B) and then push system tubing (C) into carbon pre-filter port. Replace
the red clip to lock system tubing to carbon pre-filter, shown in the picture below.
IMPORTANT: Keep black Flush tubing for future carbon pre-filter flush procedures .