10091099
– Rev1.1 – 25.02.2013 - Page 1
MultiDose
Sink / Bucket / Bottle
Instruction, Installation & Operation Manual
Page 1: ...10091099 Rev1 1 25 02 2013 Page 1 MultiDose Sink Bucket Bottle Instruction Installation Operation Manual ...
Page 2: ...position that meets all of the requirements listed below i Ensure the wall substrate is of a quality to safely mount the dispenser ii The floor around the unit must be non slip or have non slip matting to avoid slippages iii The unit must be installed in a well lit area or an area that can be lit iv Carry out a Risk Assessment for the area in which the unit is mounted Connection of Discharge Tube ...
Page 3: ... discharge spout assembly in desired position on wall below the dispenser using 2 screws and wall anchors Recommended height is 43cm 430mm to spout screw holes IV Connection of chemical feed tube 1 Fit double hose barb adaptor supplied into end of chemical inlet tube protruding from bottom of dispenser Secure with cable tie 2 Connect chemical feed tube onto other end of adaptor Secure with cable t...
Page 4: ...unting holes are 5 5cm 55mm wide and 11 7cm 117mm high F Troubleshooting When doing maintenance on equipment please ensure you are following all guidelines in the Safety section Problem Solution Unit does not prime Check pickup tube is fully immersed in chemical Check clamps shown in Fig 2 if loose replace with new cable tie Remove unit from wall Carefully unscrew collar and remove plunger and spr...
