Hydro-Force O100, Owner'S Manual

Page: 7 / 31

7
SET UP AND OPERATION:
Electrical Specifications
The Olympus is equipped with power cords and is designed to work with a 115VAC, 60hz, 15 or 20 amp
circuits. These outlets are commonly found in homes and commercial buildings.
Plug the two power cords into two outlets from different circuit breakers. Check that the Dual Circuit
Indicator green light comes on, showing the two cords are on separate breakers.
Water Supply
Use either the manual fill or the auto fill method (if equipped) to fill the solution tank with water. Hot
water can be used as long as the temperature does not exceed 130ºF.
DO NOT run out of water while
using this machine, this can damage the pump,
Manual Fill
Pour up to 10 gallons of water into the solution tank, lift the lid and pour in the manual fill opening.
Auto Fill (if equipped)
Connect the unit to the water source using a Water Supply Hose. The garden hose connection
attaches to the water source, connect the hose to the Olympus using Male Quick Connect on the
front of the unit.
Auto Pump-Out (if equipped)
Remove the cap from the pump-out outlet fitting on the back of the machine. Connect the pump-out hose
to the outlet fitting. Place the other end of the hose in a commode or drain connected to the sanitary sewer
system. Secure hose end to prevent movement during pumping. Use defoamer to prevent foam build-up
in recovery tank during cleaning and to keep foam/moisture from entering vacuums.