Hydro-Force O100, Owner'S Manual

Page: 15 / 31

- 15 -
Troubleshooting
Problem Cause Solution
Machine
not
turning on -
No power
Building circuit breaker tripped. Reset breakers or move cords to other outlets
Faulty power cord Replace cord
Faulty switches or internal wiring
Check wiring & test switches - Repair as
needed *
Solution
Pump
not running
Building circuit breaker tripped. Reset breakers or move cords to other outlets
Faulty power cord Replace cord
Faulty switches or internal wiring
Check wiring & test switches - Repair as
needed *
Pump faulty Replace pump
Low
Solution
Pressure
and/or
Pulsation
Jets too large for pressure desired Check jets size & flow rates / use smaller jets
Jets worn allowing too much flow Replace jets
Hose from solution tank restricted Repair or replace hose
Pump intake hose or fittings leaking
Repair or replace hose. Tighten clamps or
replace fittings
Solution tank empty Add water to tank
Pump faulty Repair or replace pump
Tool valve faulty Repair or replace valve
Quick connects or hoses restricted
Clean out or replace quick connects and/or
hoses
Heater Restricted with scale De-scale or replace the heater
Can't
connect
solution
hose
to machine
Pressure in lines Release pressure
Quick connects faulty Replace quick connects (AH101B, AH102B)
Wrong style/size quick connects
Replace quick connects to match connects on
machine
Heater Not
Heating
(Heated
Units Only)
Faulty switches or internal wiring
Check wiring & test switches - Repair as
needed *
Temperature Switch tripped Reset manual reset temperature switch.
Faulty temperature switches Replace temperature switches on heater
Faulty Heater Core Replace heater core
Flow too high for proper heating Use smaller jet or slow use of water
Water Starting out too cold
Heat water before filling tank – Maximum
130°F