Machines manufactured at Hydralok, Bristol, UK
Machine enquiries, sales, after sales service :
Interpump Hydraulics (UK) Ltd t/a IMM Hydraulics (UK) : Kidderminster
Page.6
TECHNICAL / DIMENSIONAL DATA
TECHNICAL/DIMENSIONAL DATA
H25ECO-QC
Capacity
3/16”- 11/4” (4 wire)
R9R/4SP
Motor
2.2KW
Gross weight in Kgs
108
Voltage
220/240-1-50HZ or
220/240 - 380/440-3-50 Hz
225/280
– 440/480 60 Hz
Standard dies
16 22 28 34 40
HANDLING/TRANSPORT
The machine will normally be shipped bolted to a wooden pallet . The bolts should be
removed and the machine lifted onto the work place using suitable lifting equipment.
ELECTRICAL INSTALLATION
All electrical installation must be carried out by a qualified electrician. Check that your
electrical installation is compatible with the motor requirements and specification supplied
with the swaging machine such as:
380 V / 3ph or 220 V / 3ph supply
230 V 1 ph or 110 V 1ph supply
IMPORTANT:
220/240V Single phase machines require a minimum 16 Amp C type motor
rated MCB / Fuse. It is not recommended to connect the machine to a domestic supply.
Install the machine as close to the socket as possible, without using long extension leads as
this increases the current demand from the machine.
PRELIMINARY CHECKS
Place the machine on a stable surface.
Where applicable, ensure that the power supply line is fitted with a differential safety breaker
and overload cut-out.
LIGHTING
The equipment does not have its own lighting and so it must be used in a suitably illuminated
area.