HHWCH51
Inst Issue 3: 18.06.15
Installation and Maintenance Instructions.
THESE INSTRUCTIONS MUST BE READ FULLY BEFORE COMMENCING INSTALLATION.
Owner / installer:
The life of this apparatus and its efficiency will be increased if
its use and maintenance is carried out in accordance with these instructions and
current statutory requirements. The installation and initial adjustments should be
carried out by a qualified and competent technician. Hydor Limited should be
consulted before substituting or fitting parts from another manufacturer. It is the
responsibility of the installer to verify that the installation is in accordance with
the following standards and the owner is given the current User’s Manual.
Any modifications to the unit or its installation, even the smallest
modification, change or elimination of security components or pieces that
influence the efficiency or loss of ventilation, will result in the CE Certification
and Hydor’s warranty being cancelled.
1. General
1.1 These instructions cover only Hydor products and do not include the
supply or installation of any safety equipment that may be required, e.g.
proper electrical isolation.
1.2 Any declarations made by Hydor about product installation and safety, are
dependent on the unit being used within installations which themselves
meet the relevant Standards and Directives of your region.
1.3 The Unit is designed to operate in normal ambient temperature of up to
55°C and up to 90% RH. The unit is not suitable for corrosive or explosive
atmospheres.
1.4 The installer should consider future maintenance and ensure the unit is
easily accessed.
1.5 This product is not intended for use by persons (including children) with
reduced physical sensory or mental capabilities or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the product by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
product.
HHWCH51
Galvanised Hot Water Coil Heater
incorrect
correct, minimum height 5mm
