FCM Series
Safety information and instructions
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 12 / 40
Bewa FCM 3160267d en-us 2012-01-24.doc
2012-01-24
Safety measures to be followed in normal operation
Do not operate the FCM unless all the safety devices function properly.
Check the product for visible damage and properly functioning safety equipment at
least once a day.
Hazards Posed by Stored Residual Energy
Note that the unit may pose a hazard as the result of residual stored mechanical and
electrical energy. Take the proper precautions when instructing personnel on the
use of the unit. Detailed information is provided in the respective chapters of this
manual.
Maintenance, Servicing and Troubleshooting
The specified adjustment, maintenance, and inspection work is to be conducted in a
timely fashion.
Secure all operating media against accidental start up.
The FCM is to be disconnected from the power supply and protected against being
inadvertently switched back on when performing any maintenance, servicing,
inspection or repair work.
Check that released threaded joints were refit tightly.
Always check the safety devices to see that they function properly after performing
maintenance work.
Modifications to the FCM
Do not make any modifications (design modifications, extensions) to the FCM
without the prior consent of the manufacturer.
Immediately replace any unit components which are not in perfect condition.
Use only original spare parts (OEM). When using non-OEM components, it cannot
be ensured that they have been designed and manufactured so as to comply with
loading and safety requirements.
Fire Fighting
When fighting a fire make sure to disconnect the unit from the power supply,
otherwise an electrical fire cannot be effectively dealt with.