Filtromat – OF5 C
1.7 Informal Safety Precautions
Always keep the operating instructions in the vicinity of the Filtromat.
Apart from the operating instructions, any and all general and local regulations
pertaining to accident prevention and environmental protection are to be made
available and observance to be maintained to them.
All safety guidelines and hazard warnings on the Filtromat must be maintained in
legible condition and replaced as required.
Filtromat components may not be opened except in normal, non-contaminated
environments. The mains cable must be pulled out before the Filtromat is opened.
Tests conducted with the housing open may only be performed by properly trained,
certified electricians. This also applies to all repair work or to any modifications to
electrical components approved by HYDAC.
Check the hoses and connection fittings for leakage daily (visual check). The
electrical components of theFiltromat are to also be regularly checked (visual check
once a month). Replace any loose connections or damaged cables immediately.
WARNING
Hydraulic systems are under pressure
The hydraulic system must be depressurized
before performing any work
HYDAC Filtertechnik GmbH
en
Page 11
BeWa OF5C 3160333a en
2008-02-06
