HYDAC FILTER SYSTEMS OFU Filtromat, Operating And Maintenance Instructions Manual

Page: 41 / 72

HYDAC FILTER SYSTEMS GMBH Setting up / assembly / integration of the filter unit | 5
BeWa OFU 3120755d en-us lq 41 / 72
5.7 Inserting the filter element
The filter unit has no filter element installed upon delivery from
the factory. Before commissioning check whether a filter ele-
ment is present in the filter housing.
Install a filter element if it is not already installed. For details,
see
Changing the filter element [
}
46] .
5.8 Commissioning
Observe and check the following points for commissioning:
ü
Install the new filter element in the filter bowl. For de-
tails, see Changing the filter element.
ü Check that the power supply cable is undamaged. Re-
place damaged cables immediately.
ü Connect the filter unit with the power supply
ü Check that the suction and pressure hoses are undam-
aged. Replace damaged hoses immediately.
ü
Check the ambient and fluid temperature.
ü
Prior to each use, match the oil type in the filter unit to
the oil type to be pumped. If you are not sure what sort
of oil is in the filter unit, or if you would like to pump a dif-
ferent type of oil than was most recently pumped, empty
the filter unit completely and replace the filter element.