6
ETS 4100S IO-Link
Edition: 2020-07-20
HYDAC ELECTRONIC GMBH
Part No.: 670032
E
The symbol means that minor injuries or damage to property can occur if
the stated precautions are not met.
CAUTION !
The symbol indicates important information or features and application
suggestions for the product used.
The symbol means that appropriate ESD-protective measures have to
be considered according to DIN EN 100 015-1.
(Cause of a potential equalization between body and device-mass as
well as the housing-mass about a high-impedance resistance (approx.
1 MOhm) e.g., with a commercial ESD wrist strap).
4.2 Intended use / forseeable misuse
Claims to defects and liability – regardless of the legal reason – do not apply in case of
unsuitable or improper installation, commissioning, use, treatment, storage, service, repair,
application of inappropriate operating equipment or under unforeseen circumstances for
which the manufacturer is not responsible.
Furthermore, the manufacturer will not accept responsibility for the determination of the
interfaces required for the installation into a system or the use and the functionality of the
product within the system.
4.3 Obligation of the operator before start-up
In accordance with the EC Machinery Directive, the measuring system is considered to be
a machine part for fitting into a system/machine. Moreover, the conformity of the measuring
system was investigated in respect of the EMC Directive.
It is therefore only permitted to start up the measuring system if it has been established that
the system/machine into which the measuring system is to be fitted satisfies the provisions
of the EC Machinery Directive, the EC EMC Directive, the harmonized standards, European
standards or the corresponding national standards.
4.4 Personal qualification and obligations
All work on the measuring system have to be carried out by qualified personnel only.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions, accident
prevention regulations and operating conditions, were authorized by the persons
responsible for the system to carry out the required work and are able to recognize and
avoid potential hazards.
The definition of “Qualified Personnel” also includes an understanding of the standards
VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
Define clear rules of responsibilities for the assembly, installation, start-up and operation.
It is obligatory to provide supervision for trainee personnel!
