5
The cover can now be lifted away
from the back plate. It may be
necessary to apply a small amount of
pressure to the grey section to
facilitate removal of the cover (fig 4).
Step 2 - Selecting a mounting position
Position the unit bearing in mind it will contain scalding hot water and should not be
accessible to children or the infirm.
Units are typically mounted above a sink or a draining board in a kitchen or similar
setting. The tap height should be convenient for the operator. Consider the possibility
that the user may wish to fill large pots as well as cups or mugs. It should be possible
to see the water level of the container being filled.
At least 110mm clearance must be left above the unit to allow later removal of the
cover for service.
Step 3 - Fastening to the wall
Ensuring a level, mark the two upper screw
positions onto the mounting surface, drill
and plug the holes with the provided plugs.
Insert the provided screws into the plugs
leaving around 3-4 mm of the thread
exposed.
Offer the unit onto the two screws and then
mark the two lower mounting holes onto the
mounting surface. Remove the unit from the
wall and drill and plug the two holes. Offer
the unit back up to the top two screws locate
and tighten the two lower screws and finally
tighten the upper screws.
Fig 4
Fig 5
Omega.qxp_Layout 1 08/03/2017 13:23 Page 5
