THIS UNIT MUST BE INSTALLED BY A SUITABLY QUALIFIED PERSON
IN ACCORDANCE WITH THE LATEST EDITION OF THE IEE WIRING
REGULATIONS AND THE UK WATER FITTING REGULATIONS.
THE SUPPLY CORD CANNOT BE REPLACED BY THE USER. IF THE
CORD IS DAMAGED THE APPLIANCE SHOULD BE RETURNED TO
THE MANUFACTURER OR AN AUTHORISED SERVICE AGENT FOR
REPLACEMENT.
IT IS RECOMMENDED THAT A FILTER IS INSTALLED IN THE PIPEWORK
TO PROTECT AGAINST LIME-SCALE BUILD UP, REDUCE SERVICE COSTS
AND EXTEND PRODUCT LIFE. LIME SCALE DAMAGE IS NOT COVERED
BY THE WARRANTY.
3. INSTALLATION
Step 1: Remove the Cover
The cover is attached to the
back by means of two pins
located at the top of the
unit and two screws at the
base of the unit. Remove
the screws first, then lift
cover upwards over the
tap stem (see right).
Step 2: Wall Mounting (Positioning)
Position the unit bearing in mind it will contain scalding water and should not be
accessible to children or the infirm. In order to remove and replace the cover of the
unit you will require a minimum 40mm clearance above the unit. Units are typically
mounted above a sink or a draining board in a kitchen or similar setting.The tap
height should be convenient for the operator. Consider the possibility that the user
may wish to fill large pots as well as cups or mugs. At least 40mm clearance must
be left above the unit to allow later removal of the jacket for service.
3
Microboil_Layout 1 07/01/2015 14:00 Page 3
