SECTION 6
OPERATION
•
When finished with the machine, place the
platform in the stowed position.
•
Carefully exit the platform using the constant
three point contact method.
•
NEVER JUMP OFF PLATFORM.
•
Park the machine on a level surface.
•
Remove key from lower control panel to
prevent unauthorized use
6.4 | STARTUP/SHUTDOWN
FIGURE 17: Rear Brake
FIGURE 18: Padlock Example
THE OPERATOR MUST BE AWARE OF THE
ENVIRONMENT. DO NOT RAISE THE PLATFORM IF
THE MACHINE IS NOT ON A FIRM, LEVEL SURFACE.
•
Check that the work area is safe.
•
It is not recommended to maneuver the unit on a slope greater than 5°.
•
Machine must be on a hard, level, surface before operation.
•
Check that bubble level is centered.
•
Engage the manual brakes on the rear casters before elevating the platform.
•
Ensure that the key in the lower control panel is in the “ON” position for the chassis or platform control.
•
Enter the work platform in the stowed position using the constant three point contact method.
•
Follow all general rules and precautions stated in this handbook.
CHECK THAT THE ROUTE OF TRAVEL TO BE TAKEN IS
CLEAR OF PEOPLE, OBSTRUCTIONS, DEBRIS, HOLES,
AND DROP-OFFS; AND IS CAPABLE OF SUPPORTING
THE MACHINE.
FIGURE 16: Bubble Level
PUSH-AROUND SERIES
PA-1030
26
Summary of Contents for PA-1030
Page 21: ...THIS PAGE WAS INTENTIONALLY LEFT BLANK 21 OPERATION SAFETY MANUAL PA1 1 S REV A ...
Page 29: ...THIS PAGE WAS INTENTIONALLY LEFT BLANK 29 OPERATION SAFETY MANUAL PA1 1 S REV A ...
Page 34: ...NOTES PUSH AROUND SERIES PA 1030 34 ...
Page 35: ...NOTES 35 OPERATION SAFETY MANUAL PA1 1 S REV A ...
