Poseidon 3266 – starting guide
HW group
Oficjalny dystrybutor:
www.atel.com.pl
45-231 Opole
tel. +48 (77) 455 60 76
ATEL ELECTRONICS
e-mail: [email protected]
ul. Oleska 121
fax. +48 (77) 455 80 56
Starting Guide - Poseidon 3266
First steps for measuring temperature with Poseidon
1) Connecting Poseidon 3266
•
Green POWER LED on RJ45 connector lights up – power supply is OK
•
Yellow LED on the RJ45 connector blinks – connection to 10 Mbit network is OK
Accessories
600 005
Temp-1Wire 3m
Temperature sensor, 3m cable (1m = 600 242 , 10m = 600 056)
600 311
Temp-1Wire-Outdoor 3m
Temperature sensor for outdoor use, food-safe steel, 3m cable
600 330
HTemp-Rack19
Temp & humidity sensor, installs into a RACK as a 1U device
600 279
Humid-1Wire 3m
Humidity sensor, 3m cable (1m = 600 278)
600 040
Poseidon T-Box
Hub to connect up to 5 sensors, 10cm cable
600 280
Poseidon T-Box2
Hub to connect 2 sensors, 3m cable
600 119
Door Contact
Door contact to detect open door, connects to a Dry Contact input (I1..I4)
600 239
Gas Leak Detector
Flammable gas detector, connects to a Dry Contact input (I1..I4)
600 240
PowerEgg
Voltage detector, 110/230V (connects to I1..I4 on the Poseidon)
Poseidon 3266
1.1) Check DIP switches. For installation, set them as shown in
the picture on the right (DIP1=Off, DIP2=Off).
1.4) Connect temperature or humidity sensor to IT bus
(Temp-1Wire or Humid-1Wire - RJ12 connector), the
connector must click-in.
1.3) Connect power adapter to an outlet (230 / 110V) and
to the Poseidon power connector.
The connector must be plugged in fully, green LED lights
up.
1.5) Connect Poseidon to Ethernet
1.2) Dry contact inputs for connecting contacts. For sensors with
Dry Contact outputs (buttons, relay contacts, door contacts)
Door Contact
600 119
Poseidon T-Box
600 040
HTemp-Rack19
600 330
Temp-1Wire 1m
600 242
PowerEgg
600 237
