Huyndai H-HT5114, Service Manual

Page: 35 / 55

- 34 -
Problems and Solutions
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your
dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
guarantee.
Problems Cause Solution
No power
indication
Power plug not connected
Plug the power cord into the power supply
TV has not been set to the
correct video input Set correct TV video input format for receiving
the player’s output signals.
No picture
Video cable not firmly
connected. Firmly insert the video cable ends to the
related terminals.
Audio cable not connected
tightly Firmly insert the audio cable ends to the
related terminals.
Power of audio apparatus is
off Turn on the power of audio apparatus.
No sound
Audio output setting is
incorrect Setup audio output correctly via the setup
menu.
Picture
distortion
Disc is dirty
Take out the disc and clean.
Fast forward/backward is
activated The picture may be distorted during fast
forward /backward playback.
Brightness
unstable or
noisy
Affected by anti-piracy circuit
Connect the player directly to TV.
No disc Load a disc.
Disc not compatible
Load a compatible disc (Check the disc format
and its colour system).
T
do he disc is placed upside
wn
Load a compatible disc (Check the disc format
and its colour system).
The disc not put in the tray
correctly Check disc is put in correctly.
Disc is dirty Clean the disc.
Player setting are incorrect Change the setting via the setup menu.
The player
does not
work
Parental lock is in effect Disable this function or reset the rating level.
No response
to key press
Interference of power wave or
other factors such as static
interference Turn off the main switch or pull out the power
plug, plug it in and turn on the power again.
Remote
control does
not work
The remote control not
pointed at the remote sensor
on the front panel of the
player Point the remote control at the remote sensor.
The remote control is out of
specified range Make sure the remote control range within 7
meters to the remote sensor.
Battery power exhausted Replace with new batteries.
Note:
This produce incorporates copyright protection technology that is protected by method claims of certain of
certain U.S. patent and other intellectual Property rights owned by Macrovision Corporation and other rights
owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is
intended for home and other limited viewing users only, unless otherwise authorized by Macrovision
Corporation. Reverse engineering or disassembly is prohibited.