138
7.2.
Configuration of Built-in Frame Reader
How to start the configuration
①
Press the ‘Menu’ button on the main screen.
②
Press the ‘Tracer’ button on the menu screen and then select the ‘Setting’ tab.
Setting Screen
•
Default Frame Material
– Set default frame material value of the Tracer UI.
•
Default Pattern Type
– Set default pattern curve mode of the Tracer UI.
•
Reset Job ID when power off
– Reset pre-assigned Job ID number when power off.
•
Default Job ID
– Set default Job ID (number only).
•
Using Job ID Prefix
– Add prefix string before Job ID.
•
Job ID Prefix
– Set prefix string (maximum 4-character).
•
Transmission Target
– Set frame data transmission target port.
•
The tracer stop button is always shown at the bottom of the menu screen.
•
You can use the tracer stop button to stop the operation of the tracer.
•
Refer to ‘Chapter 8. System Maintenance’ for the other functions.
!
NOTE
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...
