102
Frame Type
Blocking mode
Lens type
Near
vision
area
diameter
6.8.2.
Edging option
Edging type
Lens material
Bevel/Grooving position
Partial grooving
Polishing
Safety mode
Front safety beveling
Rear safety beveling
Roughing type
Feeling after roughing
Pre-roughing
Feeling mode & position
Clamp pressure
Hydrophobic mode
Size
Drilling Quality
(HDM-8000)
•
The job editor options are applied to right/left both side concurrently. But if the options
distinguish the two sides, those are applied only to the selected side.
•
Job editor is only available before edging. Job Editor is not available once the edging of a
side is completed.
!
NOTE
Summary of Contents for HPE-410
Page 1: ...PATTERNLESS EDGER HPE 410 USER MANUAL...
Page 149: ...149 HPE 410 8 4 6 Clamp You can check clamp Clamp test Clamp sensor state 1 2...
Page 166: ...166 10 3 Drawings of System 10 3 1 Drawings of Edger...
Page 167: ...167 HPE 410 10 3 2 Drawings of Blocker HMB 8000 10 3 3 Drawings of Blocker CBK 4000...
