Huvema HU 50 H, Operation Manual, Page: 4 / 37

4
1.1.13 Always keep children away from the machine. Operator must be at least
18 years old.
1.1.14 Do not wear loose clothing, gloves, neckties or jewelry (rings, watches,
etc). Keep the sleeves and the edges of the work uniform tight. Always be sure to
wear safety goggles and wear safety shoes during operation.
1.1.15 Put the long hair into a safety cap during operation no matter the operator
is a man or a woman.
1.1.16 It is recommended to wear suitable hearing protection equipment if
necessary.
1.1.17 Provide adequate light around the machine, and keep the perimeter around
the machine dry, clean and in good order. In addition, do not place anything near
the machine; otherwise it becomes an obstacle during operation.
1.1.18 Do not remove the guards from their working place during operation.
1.1.19 Disconnect the automatic supply before leaving the machine.
1.1.20 Restart the machine only after the guards and safety devices are replaced
to their position and in their good function.
1.1.21 Do not place tools, work pieces, or other items, which is not in use on the
machine, especially on the moving parts.
1.1.22 Clamp workpiece and tools completely and reliably and take off the
wrench from chuck before starting the spindle running.
1.1.23 Stop the machine before adjusting the position of the coolant nozzles.
1.1.24 Do not use compressed air to remove dust and chips, deposit on the
machine, switchboard, control unit etc.
1.1.25 Both operators and the maintenance men should read the descriptions
carefully on the caution plate attached to the machine. They should observe the
OPERATION MANUAL during their work. During operation and maintenance,
care should be taken so that the caution plate is not dirtied or damaged.
1.1.26 Always bear in mind where the emergency stop button is so that you can
operate it without delay in case of an emergency.
1.1.27 Start the machine according to the starting procedures strictly.