Huvema HU 50 H, Operation Manual, Page: 24 / 37

24
10 . Transportation, Installation and Trial Run
10.1 Transportation
The transportation and storage temperature range for the machine tool is
between -25
℃
~ +55
℃
.
Must load or unload machine according to outer sign on the packing box. Any
impact or vibration is prohibited. Must open the box carefully, otherwise it will
scratch the paint on the machine surface. After opening the box, check all the
accessories according to the packing list, check whether there is something wrong or
damaged, please inform dealer or manufacturer in time in order to solve it well, then
convey the machine with forklift. Please set a steel wire rope according to Fig.7
when conveying the machine with crane, and place some pads or soft cloth between
the machine surface and the steel wire rope, and ask for help if necessary during the
transportation .
Caution:
1. The steel-wire rope should not touch machine surface, each hand lever,
handle and handwheel. Do put wood block or soft cloth on the interface
between the steel-wire rope and the machine edge to avoid damaging the paint.
2. Before conveying the machine with the crane , move worktable to the front
end of the knee, and let the two ends of table on the knee have the same length,
tighten the longitudinal & cross locking handles at the same time .
10.2 Installation
In order to make machine run steadily and keep high machining accuracy, it
must be installed on the concrete foundation, which should be built according to the
Fig.9.The foundation should be built on solid soil. The machine will be put on the
foundation after it is already dry, then fix the bolts on the concrete, must correct it
carefully, make sure the tolerance of the machine’s levelling is under 0.04/1000 mm
in cross and longitudinal directions after tightening the bolts.
10.3 Trial Run
10.3.1 Before trial run, please clean the antirust oil on some parts of the machine
carefully, then coat a thin layer of lubricating oil on the outer surface.
10.3.2 Loosen locking handle in three directions (X, Y, Z) of machine before the
trial run.