10
MANUEL CUTTING OPERATION
1)
SWITCH ON THE MAIN SWITCH.
2)
SELECT THE MANUAL-AUTOMATIC SELECTOR TO POSITION 2.
3)
ADJUST S3 LIMIT SWITCH ACCORDING TO THE MATERIAL’S DIAMETER OR HEIGHT.
4)
PRESS B3 PUSHBUTTON TO GO UP THE BOW. ( S2 LIMIT SWITCH MUST BE IN CIRCUIT OTHERWISE THE MACHINE DOES NOT
WORK. )
5)
ADJUST THE LENGHT OF THE MATERIAL TO REQUIRED LENGHT. (BY USING S4 SWITCH.)
6)
PRESS START PUSHBUTTON. ( IN MANUAL POSITION, START PUSHBUTTON MUST BE KEPT PRESED UNTIL THE BOW LEFT S2
LIMIT SWITCH.)
7)
REGULATE THE CUTTING PRESSURE BY THE THROTTINLING VALVE.
8)
BECAUSE OF COUNTER, THE MACHINE COULD BE LOCKED. IN THIS SITUATION THE MACHINE DOES NOT WORK. UPPER LINE OF
COUNTER MUST BE PRESET AFTER THAT THE RESET BUTTON MUST BE PRESSED.
9)
FOR THE NEXT CUTTING, FOLLOW THE SOME WAY.
AUTOMATIC CUTTING OPERATION
1.
SWITCH ON THE MAIN SWITCH.
2.
SEALET B6 SELECTOR TO POSITION 2.
3.
ADJUST S2 LIMIT SWITCH ACCORDING TO THE MATERIALS DIAMETER OR HEIGHT.
4.
PRESS B3 PUHBUTTON TO THE BOW UP.
5.
SELECT B6 SELECTOR TO POSITION 1.
6.
SLIDE THE LENGHT-STOP ON THE SPINDLE UNTIL REACHING REQUIRED LENGHT AND THE TIGHTEN.
7.
PRESET THE NUMBER OF CUTS REQOIRED AND PRESS THE RESET BUTTON ON THE COUNTER.
8.
PRESS START BUTTON THE CUTTING OPERATION.
9.
REGULATE THE CUTTING PRESSURE BY THROTTING VALVE.
AFTER STARTING THE CUTTING OPERATION, YOU DO NOT NEED ANY OPERATION ELSE, BUT ACCORDING TO THE GRADE OF
METERIAL YOU SWITCH ON THE COOLANTPUMP OR NOT.
P.S.
IF THE MACHINE STOPPED WITHOUT REACHING PRESET NUMBER, THE BLADE COULD BE BROKEN OR THE MATERIAL LENGHT
COULD BE SHORTENED.
Summary of Contents for HU 270 DHG-4
Page 1: ...B A N D S A W I N G M A C H I N E S HU 270 DGH 4...
Page 15: ...15...
Page 24: ...2018 V1...
