2
INSTALLATION INSTRUCTIONS
This safety symbol is used throughout these instructions to alert you to information about unsafe actions or
situations, and will be followed by the word
DANGER, WARNING, or CAUTION.
Be Alert! Your safety and the
safety of others is involved.
DANGER – indicates immediate hazards that may result in severe injury or death. WARNING – indicates unsafe actions
or situations that may cause severe injury, death and/or major equipment or property damage. CAUTION – indicates unsafe
actions or situations that may cause injury, and/or minor equipment or property damage.
!
The following instructions are to be used for assistance with the set–up and installation of equipment, accessories,
and serviceable parts used on this vehicle and are not meant to replace any operating or safety procedures as outlined
in the Operators Manual.
Hutchinson/Mayrath
Gas Auger Drive Battery Kit,
Part No. A8269A
Install Battery Support
If the engine belt guard is already attached to the engine
mount plate, you will need to remove the guard.
1. Position the battery support bracket
(Part No.
1028507)
onto the engine mount plate as shown in
Figure 3.
Secure the bracket using the
5/16–18 x 3/4”
screws
and
5/16–18
nylock nuts provided in the kit
(do not
tighten).
2. Mount the belt guard at its original location
using the
two bolts previously installed to secure the battery
bracket,
(the belt guard will be positioned on the outside
of the battery bracket).
Tighten all hardware.
The rubber tie down strap will be used to secure the
battery after the battery has been properly installed.
Belt Guard Will Mount
on the Outside of the
Battery Bracket
Battery
Support Bracket
Engine
Mount Plate
Figure 3
Install Battery Support Bracket
