Hussmann Specialty Products CR3-D, Technical Data Sheet

Page: 1 / 14

14
1 of 14
R3-D/CR3-D
Technical Data Sheet
Rev A
Specialty Products
R3-D/CR3-D
REFRIGERATION DATA
Note: This data is based on store temperature and
humidity that does not exceed 75F and 55% R.H.
Discharge Air (F) 24
Evaporator (F) 20
Discharge Air (F) 30 (Rear Storage Only)
Note: Not recommended to control temp by regulating
coil temp allow t-stat to cycle and control temp.
Front
Btu/hr/ft*
Parallel
750
Conventional 863
Top
Parallel 250
Conventional 288
Rear Storage
Parallel 175
Conventional 201
*For all refrigeration equipment other than Hussmann,
use conventional Btu values.
DEFROST DATA
Frequency Hrs 6
OFFTIME
Temp Term °F
54
Failsafe Minutes 40
ELECTRIC or GAS Not Recommended
PHYSICAL DATA
Merchandiser Drip Pipe (in.) 1 ½*
Merchandiser Liquid Line (in.) 3/8*
Merchandiser Suction Line (in.) 5/8*
Estimated Charge (lb)***
4ft 1.2
5ft 1.5
6ft 1.8
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types. Actual
refrigerant charge may vary by approximately half a
pound.
GLYCOL REQUIREMENTS
GPM PSI
NA NA
NA NA
NA NA
These merchandisers are manufactured to meet ANSI/National Sanitation
Foundation Standard #7 requirements.
We reserve the right to change or revise specifications and
product design in connection with any feature of our
products. Such changes do not entitle the buyer to
corresponding changes, improvements, additions or
replacements for equipment previously sold or shipped.
CUL Listed
UL Sanitation