REPLACING ELECTRONIC BALLASTS
Canopy Ballasts
These ballast are located at the top of the
merchandiser inside the canopy. The switch in the
canopy operates the canopy lamps.
1.
D
ISCONNECT POWER TO THE MERCHANDISER
.
2. Remove top shelf.
3. Remove the screws that secure the lamp panel.
4. Grasping the light panel at the area where the
top of the panel and the top of the merchandis-
er meet, pull back and down until the panel
swings freely.
5. Replace ballast and reassemble parts in reverse
order.
6. Reconnect the electrical power.
REPLACING FLUORESCENT LAMPS
Fluorescent lamps are furnished with moisture
resistant lamp holders, shields and end caps.
Whenever a fluorescent lamp is replaced, be
certain to reinstall the lamp shields and end caps.
The switch in the canopy operates the canopy
lamps.
Plastic Shield
End Cap
Fluorescent
Lamp
Left End
Screw
Locations
Detail
Shows Wiring in Place, with Return Grille Installed.
Feed Wire
Through
Bushing
(Return Grille
Removed)
