Hussmann ASCS, Installation And Operation Manual

Page: 3 / 40

Rev.0303
3
Cut & Plan Views
Installation
LOCATION
The refrigerated merchandisers have been designed for
use only in air conditioned stores where temperature and
humidity are maintained at or below 75°F and 55% relative
humidity. DO NOT allow air conditioning, electric fans,
ovens, open doors or windows (etc.) to create air currents
around the merchandiser, as this will impair its correct
operation.
Product temperature should always be maintained at a
constant and proper temperature. This means that from
the time the product is received, through storage,
preparation and display, the temperature of the product
must be controlled to maximize life of the product.
UNCRATING THE STAND
Place the fixture as close to its permanent position as
possible. Keep in place, attached case until ready to set/
bolt to adjoining case.
TIGHTEN GLASS SCREWS
Tighten screws along clamshell located on the underside
of glass before placing unit into operation.
EXTERIOR LOADING
These models have not been structurally designed to
support excessive external loading. Do not walk on their
tops . This could cause serious personal injury and damage
to the fixture.
SETTING AND JOINING
The sectional construction of these models enable them
to be joined in line to give the effect of one continuous
display. A joint trim kit is supplied with each joint.
ASC with
22 1/2º Wedge
ASC with 22 1/2º Wedge
ASCS
Single Deck Refrigerated Service
Scale = 1/2"
3
4
"
2
0
1
/ 8
"
2
3
"
4
5
5
/ 8
"
1
1
"
45"
29 1 /
2
" 4"
30 3 /
4
"
8 3 /
4
"
11 1 /
2
"
6 1 /
4
"
45"
8"
CASE FRONT
11"
ASCS
Plan View
Scale = 1/4"
DRAIN
MECHANICAL
STUB UP AREA
19" X 19"
WATER, ELEC.
& REFRIG.
MECHANICAL
STUB UP AREA
19" X 19"
8'-2"
(VARIABLE LENGTHS)
1"
1"