wc_tx004557en.fm
26
Operation
MCT36-5 CN
4.12
Position of the Operator
Safe and efficient use of this machine is the operator’s responsibility. Full control of
the machine is not possible unless the operator maintains the proper working
position at all times.
While operating this machine the operator must:
stand or walk behind the machine, facing forward
have both hands on the control handle
guide the motion of the trowel by applying downward pressure to the control
handle
4.13
Operation
1. Confirm proper attachment of the blades to the trowel arms.
Notes:
When operating on soft concrete, do not let the trowel stand in one spot too
long. Always lift the trowel from the slab when operation is complete.
“Left” and “right” references are made from the operator's position.
2. Adjust the handle height to suit the operator. See
Adjusting Handle.
NOTICE:
Do not attempt to adjust the handle height on the trowel while it is
running.
3. Adjust the blade pitch (angle) by turning the pitch control knob. See
Controls
.
Turn the pitch control knob clockwise to increase pitch and counterclockwise to
decrease pitch.
4. Start the engine and engage the blades by increasing the engine speed. Set the
speed with the throttle on the handle to the appropriate speed for the job
conditions.
5. To move the trowel forward, twist the handle clockwise
(a)
.
6. To move backward, twist the handle counterclockwise
(b)
.
7. To move left, lift up slightly on the handle
(c)
.
8. To move right, press down slightly on the handle
(d)
.
9. Clean the trowel after each use to remove concrete splatter.
This procedure continues on the next page.
WARNING
Test the function of the engine control module before operating the trowel. DO
NOT operate the trowel if the engine control module is not functioning properly.
WARNING
Allow the muffler to cool before cleaning or servicing the machine. A hot muffler
could ignite the fuel and start a fire.
