Husqvarna VIKING Designer EPIC, User Manual

Page: 37 / 202

Threading for Twin Needle
Replace the sewing needle with a twin needle. Make sure that
the presser foot and needle are in the up position.
1. Raise both spool pins to vertical position. Place a thread
spool on each spool pin.
Using both hands, place the thread from the main spool
pin behind the left clip on the telescopic thread guide
(A), from right to left, and then place the thread from
the auxiliary spool pin behind the right clip on the
telescopic thread guide (B), from right to left.
Note: Do not place the thread from the auxiliary spool pin
behind both clips on the telescopic thread guide, as this will create
too much thread tension.
Note: When using large thread cones on the auxiliary spool pin, place
the large spool holder with the flat side up and a cone holder on the spool
pin before adding the thread cone.
2. Hold both threads with two hands as illustrated. Floss
the threads under the thread guide (A) from front to
back. Pull the threads together back into and through
threading slot (B).
Note: Continue to hold the threads lightly next to the thread guide
(A) throughout the threading process. This will create a bit of
tension on the threads and ensure that the threads are properly
seated in the threading path.
2 Preparations 37