Husqvarna VIKING Designer EPIC, User Manual

Page: 149 / 202

Bobbin Thread Low
When the bobbin thread is running low, a pop-up message
appears giving you advance notice that you will soon need to
change the bobbin. This gives you an opportunity to plan
when you want to change your bobbin.
It is possible to embroider until the thread has completely
run out. Without closing the pop-up, touch the start/stop
button, or the foot control, to continue embroidering.
Touch cancel to remain at the current stitch position.
Touch OK to move the hoop to the center/remove hoop
position. The hoop position pop-up opens. Replace the
empty bobbin with a full one. Touch current position in the
pop-up and pull back any excess length of needle thread.
Touch the start/stop button to continue embroidering.
Check Upper Thread
The machine stops automatically if the upper thread runs out
or breaks. Re-thread the upper thread from the beginning,
close the pop-up message and then go back a few stitches
using the step stitch-by-stitch control to ensure that the
thread will be secured. Re-start your embroidery.
9 Embroidery Stitch Out 149