Husqvarna TX 125, Owner'S Manual, Page: 94 / 146

15 ELECTRICAL SYSTEM
92
F00343-10
Main work
–
Turn protection cap

together with the underlying bulb socket counterclock-
wise all the way and remove it.
–
Pull bulb socket

of the parking light out of the reflector.
F00361-10
–
Pull out headlight bulb

.
–
Insert the new headlight bulb.
Headlight (HS1/socket BX43t) ( p. 131)
–
Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
O-ring  is correctly positioned.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. ( p. 91)
–
Check the headlight setting. ( p. 93)
15.8 Changing the turn signal bulb (TE 250/300 EU/AU)
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
F00362-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass

.
–
Lightly squeeze orange cap

in the area of the holding lugs and take it off.
–
Press the turn signal bulb lightly into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W/socket BA15s) ( p. 131)
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn counterclockwise until it engages in the thread with
a small jerk. Tighten the screw lightly.
Finishing work
–
Check that the turn signal system is functioning properly.