19 CLEANING, CARE
111
19.1
Cleaning the motorcycle
Note
Material damage
Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
401061-01
–
Close off the exhaust system to prevent water from entering.
–
Remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a
paintbrush.
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle
with water first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry
thoroughly.
–
Remove the closure of the exhaust system.
–
Empty the carburetor float chamber.
Warning
Danger of accidents
Moisture and dirt impair the brake system.
–
Brake carefully several times to dry out and remove dirt from the brake
linings and the brake discs.
–
After cleaning, ride a short distance until the engine reaches operating tempera-
ture.
Info
The heat produced causes water at inaccessible locations in the engine
and on the brake system to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
–
Treat bare metal parts (except for brake discs and exhaust system) with anti-
corrosion materials.
Preserving materials for paints, metal and rubber (
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care
product.
(TE 250/300 EU/AU, TX 125 EU)
–
Lubricate the steering lock.
