Husqvarna TR 650 STRADA 2013, Workshop Manual, Page: 95 / 301

F.3
TR 650 TERRA 2013 - TR 650 STRADA 2013
H10182
H11483
1
2
H11484
H11485
4
3 3 3 3
H11486
4
5
Workshop Manual Ed.09-2012
ENGINE SETTINGS AND ADJUSTMENTS
VALVE CLEARANCE CHECK
Remove the coil / spark plug cap, spark plugs and the head cover as described
in chapter "F1".
Valve clearance check
- Remove the screw plug (1).
- Place an Allen wrench into the hole (2) and turn the crankshaft in the normal
sense of rotation until the ignition TDC.
- the marks (3) placed on the crankshaft gears must be coplanar to the sealing
surfaces and the holes (4) must face upwards.
- In this position, both cams of the intake and exhaust camshafts must face
upwards and be at the same angle relative to the upper face of the head.
Valve clearance measurement
Measure valve clearance using a feeler between the cam and valve bucket both
for the intake (4) and exhaust (5) cams.
Note down the measurements on a measurement sheet.
Technical specifications
Intake valve clearance with cold engine
max. 35 °C
0.23 - 0.28 mm
0.0091 - 0.011 in.
Exhaust valve clea-
rance
with cold engine
max. 35 °C
0.38 - 0.43 mm
0.015 - 0.016 in.
If the valve clearance does not lie within the correct tolerance, correct clearance
must be restored by replacing the pads beneath the valve buckets.
- Reassemble the screw plug (1) and all other parts removed.