Husqvarna TR 650 STRADA 2013, Workshop Manual, Page: 300 / 301

Y.13
TR 650 TERRA 2013 - TR 650 STRADA 2013
H10901
H10902
H10903
1
2
1
1
1
1
12
16
1
C
MAX
MIN
Workshop Manual Ed. 09-2012
CHASSIS AND WHEELS
Wheel axle warpage
Use a feeler gauge to check the pint out-of-round; if the value of the warpage
exceeds the max allowed limit, replace it.
Axle runout over 100 mm
Wheel axle Standard Max. limit
Wheel axle less than 0.1 mm 0.2 mm (0.079 in.)
less than 0.039 in.
PIN
FRONT
Wheel rim warpage
The table below reports the allowed limits for wheel rim warpage. An excessive
side runout and out-of-round are generally caused by worn out bearings. In
these cases, replace the bearings and the sealing rings. If this does not solve
the problem, change the wheel rim or the wheel.
Standard Max. limit
Side runout less than 0.5 mm (0.02 in.)
2 mm (0.079 in.)
Out-of-round less than 0.8 mm (0.03 in.)
PIN
REAR